Router EZSetup Example Forms

Router ISDN EZSetup

Note This is a sample form only. Do not use this form to configure your router. When you are ready to configure your router, return to Configure the Router and select the hotlink click here.

Router ISDN EZSetup

To configure your router, you have to fill in the fields on this form. Most of the information required should have been supplied by your network manager or Internet service provider.

Router Name

You need to name your router. The router name must be the name that you were given by your network manager.

Router name __________

ISDN Interface

You need to know the name of the router that you will be dialing, the phone number, and the protocol. If you choose PPP, CHAP authentication (without password), unnumbered IP routing will be used automatically. If you choose CPP for your protocol, please enter the MAC address of the remote router to set up the profile ID. If you need to configure routing with CPP, enter the IP address for the ISDN interface.

You also need to know the type of ISDN switch that the phone company is using, and you might need to know the SPIDs that they have assigned to you. If they are not using SPIDs, you can leave those fields blank.

Central site router name __________

Central site phone number 1 __________

Central site phone number 2 __________

Protocol

CPP
PPP

Central site router's MAC address __________

IP address for ISDN interface __________ISDN switch type

ISDN Service Profile Identifier (SPID) 1 __________

ISDN Service Profile Identifier (SPID) 2 __________

Directory number 1 __________

Directory number 2 __________

IP Addresses

Router IP address __________

Router subnet mask __________

Mode of Operation

You can configure a Cisco 700 series router to work as a bridge or an IP router.

Please choose one of the modes below.

Bridging
Routing

Return to Configure the Router.

Return to ClickStart Home Page.

Table of Contents