Table of Contents
About This Guide
About This Guide
This section discusses the objectives, audience, organization, and conventions of this hardware installation and configuration guide.
Objectives
This publication will step you through the initial site preparation, installation, and configuration of the router. Troubleshooting and maintenance procedures, and cable specifications are also provided.
Timesaver Use the quick reference card that came with your router for quick cabling instructions.
Audience
This publication is designed for the person installing the router, who should be familiar with electronic circuitry and wiring practices and have experience as an electronic or electromechanical technician.
Organization
The major sections of this hardware installation and configuration guide are as follows:
- Chapter 1, "Overview," discusses the features and specifications of the router, and describes how to obtain technical support and order documentation.
- Chapter 2, "Preparing to Install the Router," discusses environmental requirements, safety recommendations, and describes the various ports and how to prepare for connections between networks and ports.
- Chapter 3, "Installing the Router," includes basic installation information and discusses making connections to your LAN, WAN, and console terminal.
- Chapter 4, "Configuring the Cisco Multiport Serial Routers," discusses configuring the terminal and modems and other asynchronous devices attached to the multiport routers manually using configuration mode, using AutoInstall, or manually using the setup facility.
- Appendix A, "Troubleshooting the Router," discusses how to isolate problems and read the LEDs.
- Appendix B, "Maintaining the Router," discusses selected maintenance procedures.
- Appendix C, "Cable Specifications," provides pinouts for the router ports and cables.
Conventions
This publication uses the following conventions to convey instructions and information.
Command descriptions use these conventions:
- Commands and keywords are in boldface font.
- Variables for which you supply values are in italic font.
- Elements in square brackets ([ ]) are optional.
- Alternative but required keywords are grouped in braces ({ }) and are separated by vertical bars ( | ).
Examples use these conventions:
- Terminal sessions and information the system displays are in
screen
font.
- Information you enter is in
boldface screen
font.
- Nonprinting characters are in angle brackets (< >).
- Default responses to system prompts are in square brackets ([ ]).
Note Means reader take note. Notes contain helpful suggestions or references to materials not contained in this manual.
Timesaver Means the described action saves time. You can save time by performing the action described in the paragraph.
Caution Means reader be careful. In this situation, you might do something that could result in equipment damage or loss of data.
Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, you must be aware of the hazards involved with electrical circuitry and familiar with standard practices for preventing accidents. (To see translated versions of this warning, refer to the "Regulatory Compliance and Safety Information" document that accompanied the router.)
Copyright 1988-1996 © Cisco Systems Inc.
