Router Setup Example Forms

Router Asynchronous Serial EZSetup

Note This is a sample form only. Do not use this form to configure your router. When you are ready to configure your router, return to Configure the Router and select the hotlink click here.

Router Asynchronous Serial EZSetup

To configure your router fill in the fields below. Most of the information required should have been supplied to you by your network manager or service provider.

Router Name and Password

Name your router and give it a password. The router name must be the name that you were told to use. The password is your choice.

Router name
Router password

Asynchronous Serial Interface

You need to know the name of the router you will be dialing up, and the password used for CHAP authentication on the link. This CHAP password should have been supplied to you, and is different from the router password above.

Remote router name
Remote phone number
Remote CHAP password

Enter a password to be prompted when a user dials into this router.

Local line password

Select the speed of the modem connected to the router and enter the Modem initialization string.

Modem Speed 14.4k 28.8k
Modem Initialization String IP Addresses Router IP address Router netmask DNS server IP address Diagnostic Information You may want to enable some standard debugging information. This will have little or no impact on performance but will help diagnose WAN and Dial-On-Demand problems. Debugging information is sent to the console and is stored in an internal buffer. Please choose one of the options below. Enable standard debug Disable debug Return to Configure the Router. Return to ClickStart Home Page. Copyright 1988-1996 © Cisco Systems Inc.

Table of Contents