Router Setup Example Forms

Router ISDN EZSetup

Note This is a sample form only. Do not use this form to configure your router. When you are ready to configure your router, return to Configure the Router and select the hotlink click here.

Router ISDN EZSetup

To configure your router, you have to fill in the fields on this form. Most of the information required should have been supplied by your network manager or service provider.

Router Name and Password

You need to name your router and assign it a password. The router name must be the name that you were told to use. You can choose the password.

Router name

Router password

ISDN Interface

You need to know the name of the router that you will be dialing, and the password used for CHAP authentication on this link. You also need to know the type of ISDN switch that the phone company is using, and you might need to know the SPIDs that they have assigned to you. If they are not using SPIDs, you can leave those fields blank.

Remote router name

Remote phone number

Remote CHAP password

ISDN switch type

ISDN Interface Speed

56k
64k

ISDN Service Profile Identifier (SPID) 1

ISDN Service Profile Identifier (SPID) 2

IP Addresses

The router uses an address of 171.69.89.60. You can change it.

Router IP address

Router netmask

DNS server address

Diagnostic Information

You may want to enable some standard debugging information. This will have little or no impact on performance, but will help diagnose ISDN and dial-on-demand problems. Debugging information is sent to the console and is stored in an internal buffer.

Please choose one of the modes below.

Enable standard debug
Disable debug

Return to Configure the Router.

Return to ClickStart Home Page.

Table of Contents